Product design is an intense aspect of the injection molding manufacturing process. Precise design is to achieve the desired goal to a pleasant level, but it may require a lot of creativity. Product design is usually done through the application of computer aided design, and a few specific techniques to avoid the error of high prices in the product design process as symmetrical as possible wall thickness decisions, and gradually transition from one thickness to another when thickness changes are unavoidable.
The application scope of plastic products is more and more extensive, such as: household appliances, instruments and meters, building equipment, automobile industry, daily hardware and many other fields, the proportion of plastic products is rapidly increasing. However, with the rising trend of industrial products and daily products of plastic, the strength and precision of plastic products and other aspects are also improving, therefore, in order to make the mold to obtain better strength and precision, it is necessary to carry out two-color mold injection processing technology.
UV plastic injection molded parts is a kind of surface treatment technology, the surface of the general plastic injection molded parts, after UV treatment can make the product surface effect more bright, and it is not easy to be scratched, main technological sprayed on the surface of a layer of transparent oil, need to dry after UV light, explain to everybody below the plastic injection molded parts
In the process of injection molding, injection molding products are due to high temperature. This is easy to cause plastic parts to burnt. Today we will take stock of what factors will cause injection molding products to burnt.
The cooling time of the part usually refers to the period of time from when the plastic melt fills the cavity of the injection mold until the part can be opened and taken out. The time standard for taking out the part by opening the mold is often based on the part that has been fully cured, has a certain strength and rigidity, and will not be deformed and cracked when the mold is opened and ejected.
There are many reasons for the sticking and poor demoulding of injection molding products, and mold failure is one of the main reasons. The causes and treatment methods are as follows:
