Injection molding material does not meet the application requirements will also lead to the appearance of poor luster.
With the development of science and technology, plastic products have already become a kind of product that can not be replaced in our daily life. In real life, plastic products have almost occupied various categories. For example, in life, friends can see cars, boats, planes, computers, telephones and other few materials at any time, and a few of their plastic accessories are molded by plastic molds. When a product is born, it is necessary to open a mold, and we need to find a mold factory, often think that injection mold and plastic mold is the same meaning, hot ask about the difference between plastic mold and injection mold, please read this article, will take you to ask about the difference between!
The burrs, also known as flying edge, overflow, overflow, etc., mostly occurs in the parting position of the mold, such as: the parting surface of the mold, the sliding part of the slider, the cracks of the insert, the pores of the ejector rod, etc. If the overflow is not solved in time, it will be further expanded, so as to form part of the embossed mold collapse, causing consistent obstruction. Cracks in inserts and top bar pores also cause the product to get stuck on the mold, affecting the release.
Product design is an intense aspect of the injection molding manufacturing process. Precise design is to achieve the desired goal to a pleasant level, but it may require a lot of creativity. Product design is usually done through the application of computer aided design, and a few specific techniques to avoid the error of high prices in the product design process as symmetrical as possible wall thickness decisions, and gradually transition from one thickness to another when thickness changes are unavoidable.
The application scope of plastic products is more and more extensive, such as: household appliances, instruments and meters, building equipment, automobile industry, daily hardware and many other fields, the proportion of plastic products is rapidly increasing. However, with the rising trend of industrial products and daily products of plastic, the strength and precision of plastic products and other aspects are also improving, therefore, in order to make the mold to obtain better strength and precision, it is necessary to carry out two-color mold injection processing technology.
UV plastic injection molded parts is a kind of surface treatment technology, the surface of the general plastic injection molded parts, after UV treatment can make the product surface effect more bright, and it is not easy to be scratched, main technological sprayed on the surface of a layer of transparent oil, need to dry after UV light, explain to everybody below the plastic injection molded parts